Assuming no subnetting, which two pieces of information can
be derived from the IP address 144.132.25.10? (Choose two)

A. It is a Class C address

B. It is a Class B address

C. The network address is 144.0.0.0

D. The network address is 144.132.25.0

E. The host spoon of the address is 25.10

Answers were Sorted based on User's Feedback



Assuming no subnetting, which two pieces of information can be derived from the IP address 144.132...

Answer / guest

Answer: B, E

Is This Answer Correct ?    8 Yes 2 No

Assuming no subnetting, which two pieces of information can be derived from the IP address 144.132...

Answer / krishna

b, d

Is This Answer Correct ?    3 Yes 7 No

Post New Answer

More CCNA Interview Questions

What is difference between switch & hub?

0 Answers  


I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1

2 Answers  


Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,


as we know that isdn bri port come with either a u interface or some thing s/t interface what is the diffrenmce between them

2 Answers   HCL,


What are the differnt memory use in cisco router?

0 Answers  






What is the difference between bus topology and hub?

0 Answers  


Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  


What is the terminal emulation, in which layer it comes?

0 Answers  


What command displays only OSPF routes?

2 Answers  


What is masking? why is needed?

4 Answers  


What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  


Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery

1 Answers  


Categories