What is the difference between static and dynamic ip addressing?

0 Answers  

---

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

4 Answers   TCP,

---

In stead of 0.0.0.0 wild card mask what you can write after ip?

0 Answers  

---

IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds

1 Answers  

---

Identify the 2 items that TCP and UDP share in common? A.) Both use port numbers to identify upper level applications B.) Operate at the Network layer C.) Both are Transport protocols D.) Both are reliable communications

1 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

1 Answers  

---

Define bandwidth?

0 Answers  

---

Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...

3 Answers  

---

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

Which Cisco IOS command should you use to display the Novell IPX address assignments on a router? A. show ipx addresses B. show ipx interface C. show me the money D. ipx, network (number) E. display ipx addresses F. show ipx routing details

1 Answers  

---

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Console E.) Trace

2 Answers  

---