1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Identify 3 ways in which a router can be configured?

A.) TFTP

B.) Nvram

C.) ROM

D.) Console

E.) Trace

Question Posted / guest

Answers were Sorted based on User's Feedback



Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Cons..

Answer / guest

Answer: A B D

Is This Answer Correct ?    6 Yes 2 No

Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) ROM D.) Cons..

Answer / amir golgozar

A
B
D

Is This Answer Correct ?    4 Yes 0 No

Post New Answer

More CCNA Interview Questions

Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification

1 Answers  

What is a back off on an 802.3 networks? A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. It is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged

1 Answers  

Explain what is formula of hold down time of eigrp protocol?

0 Answers  

What is an advantage of local area network (LAN) segmentation? A. smaller collision domains B. elimination of broadcasts C. decreased cost of implementation D. larger number of users within the same domain

3 Answers   Cisco,

Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24

1 Answers  




Explain on which interface we always apply access-list?

0 Answers  

What is the total bandwidth of all channels on a BRI circuit? A. 56 kps B. 64 kps C. 112 kps D. 128 kps E. 144. kps

5 Answers   Infosys,

Which of the following is True regarding passwords on a Cisco router? A. All passwords can be encrypted B. All passwords can be entered using the set-up dialogue C. A password can be set before a user can enter the privileged mode D. A password can be set for individual lines E. TACACS or Radius password authentication can be used.

1 Answers   TATA,

Which statement is true regarding Administrative distance? A.) It is a metric B.) Number of hops between two routers C.) Trustworthiness of the routing information D.) RIP Administrative distance is 100

1 Answers   TCS,

In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A

1 Answers  

Which two types of route table entries are used by a Layer 3 router to determine the appropriate path to destination? (Choose two) A. static route entry B. default route entry C. Dynamic route entry D. temporary route entry E. permanent route entry

2 Answers  

Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload

1 Answers  

For more CCNA Interview Questions Click Here
Categories