ARP is what type of protocol?
a. broadcast
b. multicast
c. unicast
d. routing
- 1 Answers
- 1969 Views
- I also Faced
- E-Mail Answers
Protocols that support multipath LAN to LAN communication are what type of protocols.
SNMP is based on..
What servers maintain the top-level zones (com, net, edu).
Which is the RIP daemon in Solaris ?
What is DTE and DCE in terms of Router Configuration and what is the purpose of DTE and DCE differentiate?
Solaris will run routed if the default route is not defined in the __ file .
Draw network configuration and protocol layer interface architecture for a multiprotocol bridge that interconnects an Ethernet LAN to a token-ring LAN.
0 Answers Kent, Kent State University,
I have to do a VLAN connection. I have a managed switch 2950 with 48 ports there r 34 pc connected through switch My aim is to create 3 VLAN. I want to use the IP adress 192.168.10.2 to 10.12 for VLAN1 so what could be the default gateway address of VLAN1.
Which command will show all info on packet#220 from file /home/adm/packets ?
What agent accepts messages from mail user agent. resolves destinations addresses, selects proper mailer to deliver mail, and receives incoming mail from other mail transfers agents.
What is "keepalive"? a. A keepalive is a small, layer-1 bit message that is transmitted by a network device to let directly-connected network devices know of its presence. b. A keepalive is a small, layer-2 message that is transmitted by a network device to let directly-connected network devices know of its presence. c. A keepalive is a small, layer-2 message that is transmitted by a network device to let it neighbors know of congestion d. A keepalive is a small, layer-3 message that is transmitted by a network device to let directly-connected network devices know of its presence. e. A keepalive is a small, layer-3 message that is transmitted by a network device to let it neighbors know of congestion
Which file serves as the configuration file for sendmail ?
Networking Protocols 
