What category or categories does Client/Server fit into the
following Job Aid?
Name of Protocol Type of Protocol # of Users # of Hosts or
Servers Comments
What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR
What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer
In an ATM network, which type of device is in a LAN per ELAN (Emulated LAN)? A. LAN Emulation Workstation B. LAN Emulation Router C. LAN Emulation Server D. LAN Emulation Bridge
When is the route to a node determined in an SRB (Source Route Bridging) Token Ring network? A. Before any data is transmitted B. After the data is transmitted C. During the transmission of data D. After the first frame is transmitted
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information
Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network
What device initiates a session in an X.25 network? A. DTE B. DCE C. PSE D. PAD
Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above
Which address is updated at each hop in the path in path switching?
What network design is becoming common when there is a central office with one or more remote locations? A. ISDN PRI at the central location and ISDN BRI at the remote locations. B. Using core routers at all sites C. Only using access routers D. Using a full mesh network
When should you apply SAP filters to Netware service advertisement messages? A. When services are not required for a particular area or network B. Only after service advertisement messages have flooded the network C. Before any type of router convergence takes place D. When no change in network services has taken place for 40 minutes