Answer / guest

Answer: B

Answer / aman mishra

answer:-b

Answer / udaiveer

flash memory

Which type of routing you did in ccna?

0 Answers  

---

How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?

7 Answers  

---

What is the network subnet?

0 Answers  

---

In which three situations is a hold down timer reset? (Choose three) A. when the hold down timer expires B. when infinity is finally defined as some maximum number C. when the router exchanges update summaries at area borders D. when the router detects faulty LSPs propagating through the internetwork E. when another update is received indicating a new route with a better metric F. when another update is received indicaing the original route to the network has been restored G. when the router receives a processing task proportional to the number of links in the internetwork

1 Answers  

---

I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1

2 Answers  

---

Which two statements are true? (Choose two) A. Ethernet 802.3 utilizes a half duplex method for data transfer B. In a 100 MBS point to point connection a full duplex connection can provide 400 Mbs of data transfer C. Ethernet switches can use the full duplex mode to connect multiple nodes on a single pod of a switch D. Full duplex Ethernet takes advantage of UTP using one pair for transmission and the other pair for reception

1 Answers  

---

What is the routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) TTL D.) Hop count

1 Answers  

---

What is the total bandwidth of all channels on a BRI circuit? A. 56 kps B. 64 kps C. 112 kps D. 128 kps E. 144. kps

5 Answers   Infosys,

---

GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong

0 Answers  

---

What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable

2 Answers  

---

In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A

1 Answers  

---

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers   Intel, Quark, Wipro,

---