Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

2 Answers  

---

Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP

1 Answers  

---

Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1

2 Answers  

---

What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

1 Answers  

---

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

4 Answers  

---

Explain what is the default behavior of access-list?

0 Answers  

---

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

3 Answers  

---

Write the procedure for Router for configuring DHCP?

4 Answers  

---

What is the difference among straight cable, cross cable and rollover cable?

0 Answers  

---

Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com

20 Answers  

---

What is the command to copy the IOS image to a TFTP server? A.) copy flash tftp B.) copy running-config tftp C.) copy ios tftp D.) copy startup-config tftp

2 Answers  

---

Identify 3 UDP characteristics? A.) Reliable communication protocol B.) Applications that use UDP must incorporate reliability C.) Connnection-less oriented D.) Incorporates no handshaking

2 Answers  

---