Answer / bala

B.Signal type.

BASE means the baseband signal.

Answer / guest

Answer: B

Answer / s.m.feroz ahmed

100BaseT refers to A. Cabling Type.

Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  

---

Identify the 2 commands that save the running-config to a TFTP server? A.) write running tftp B.) copy running network C.) copy running tftp D.) write network

3 Answers  

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

---

What is difference between switch & hub?

0 Answers  

---

How many ports are present in a router?

0 Answers  

---

What command can you type to view the connections after telneting into multiple routers simultaneously? A.) sh users B.) sh ports C.) sh host D.) sh sessions

1 Answers  

---

How does PPTP encapsulate data?

0 Answers   CCIE,

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,

---

Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

1 Answers  

---

Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---