What command displays only OSPF routes?
Answers were Sorted based on User's Feedback
Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share
What is point-to-point protocol in ccna?
You have a Class B network address divided into 30 subnets. You will add 25 new subnets within the next year. You need 600 host IDs for each subnet. Which subnet mask should you use? A.) 255.254.0.0 B.) 255.192.0.0 C.) 255.255.252.0 D.) 255.255.248 0
Which command can verify Application Layer connectivity between 2 hosts? A.) ftp B.) snmp C.) telnet D.) ping E.) traceroute
Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells
Define network congestion?
what is used for passive intercae comand mine answer-to prevent to take update from outside
Which peer authentication method and which ipsec mode is used to connect to the branch locations?
How many ports are present in a router?
whats the routing protocol supporting in both juniper , cisco routers.
Which port are used by Viruses? TCP or UDP?
Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -