Answer / guest

Answer: A, D, E

Answer / krishna

switch works witch only frames not witch packets here ans
is b:only if its mac address d with using vlans a:by using
stp

Answer / nathan

a,c,e

what is the diffination of bandwidth.

2 Answers  

---

Identify the default IPX serial encapsulation? A.) Novell-Ether B.) SDLC C.) SNAP D.) HDLC

1 Answers  

---

Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination

3 Answers  

---

Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP

4 Answers  

---

Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network

3 Answers  

---

what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain

5 Answers   IBM,

---

What is the key advantage of using a switches?

0 Answers  

---

What are 3 ways to provide login access to router? A.) Console B.) TFTP C.) Rlogin D.) Auxiliary Port E.) X Windows F.) Telnet

2 Answers  

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks

1 Answers  

---

How many fillers we can put in one ip of ipv6?

0 Answers  

---

Which three pieces of CDP information about neighbours routers are displayed on your console terminal? (Choose three) A. neighbours router a host name B. the neighbours router a hardware platform C. up to one address for each protocol supported D. up to two addresses for each protocol supported

1 Answers  

---