What is the default IPX Ethernet encapsulation?
A.) SNAP
B.) Arpa
C.) 802.2
D.) Novell-Ether
E.) SAP
Answers were Sorted based on User's Feedback
what is AD Value?
Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE
Which command specifies a second subinterface on serial interface 0? A. interface s 0.2 point-to-point B. interface 2 s.0 point-to-point C. suberinterface 2.s 0 point-to-point D. interface s 0 sub 2 point-to-point E. interface s 0.1 point-to-point sub 2
How many collisions are caused by transmitting and receiving frames simultaneously in a full-duplex Ethernet technology? A. one B. two C. none D. several
Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56
Which of the following is a valid extended IP access-list? A.) router(config)# access-list 101 permit tcp host 172.16.30.0 any eq 21 log B.) router# access-list 101 permit tcp host 172.16.30.0 any eq 21 log C.) router(config)# acess-list 101 permit any any 172.16.30.0 D.) router(config)# access-list 101 permit ip host 172.16.30.0 any eq 21 log
Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp
Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM
What is the correct command line syntax for configuring a port on a 7000 or 7500 series Cisco router with a VIP card? A.) port B.) port adapter/port C.) You can't put a VIP card in a 7000 or 7500 router. D.) slot/port-adapter/port E.) slot/port F.) slot
Select the fields for the Cisco HDLC protocol: A. Flag, Address, Control B. Flag, Address, Control, Protocol, LCP (Code, Identifier, Length, Data), FCS, Flag C. Flag, Address, Control, Data, FCS, Flag D. Flag, Address, Control, Proprietary, Data, FCS, Flag