Identify the 2 commands that will display the status and
information about interface E0 only?
A.) show interface ethernet E0
B.) show interface E0
C.) show E0
D.) show int E0
E.) show interface
What is the subnetmask of / 27 in network based and host based?
what is vlan and how will you configure vlan on 3650 switch and how many valn can you create on that switch
Assume that you are editing a line of text on a Cisco router. What key-stroke combination would take you to the beginning of the line? A.) CTRL-B B.) CTRL-Z C.) CTRL- D.) CTRL-A E.) CTRL- F.) CTRL-
Operation of two PC connecting with brand new switches. (they expecting step by step arp ,broadcast,MAC table, RARP operation)
Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control
what is difference between 1 pap and chap(quite easy but need on line answer) 2 chap and ms-chap(plz describe briefly) now i have posted the question is there any one to help me?
Which NetWare protocol provides link-state routing? A. NLSP B. RIP C. SAP D. NCP
Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'
What is the difference between bus topology and hub?
Novell NetWare has an Ethernet frame type called Ethernet_II. What is the matching Cisco command line keyword for this encapsulation method? A.) dix B.) sap C.) arpa D.) gns E.) snap F.) novell-ether
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecting to non-Cisco equipment C.) You must use Q.933a encapsulation if connecting to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP