Interested to Buy Any Domain ? << Click Here >> for more details...
What is the standard ISDN term for a non-native analog
telephone?
A.) TE1
B.) TA
C.) LE
D.) TE2
E.) ET
- 1 Answers
- 5419 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
Terminal Equipment 2 (TE2) does not support native digital
ISDN. The
analog device will require an external analog to digital
converter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config
Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame
What command will display all connected OSPFv2 routers?
Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities
When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version
Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router
What requirements should a VPN fulfill?
Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A) telnet B) ping C) trace D) bootp
What does the following line for an access list do? 'access-list 101 deny tcp 3.4.5.0 0.0.0.255 any eq 23' A.) deny all ftp traffic B.) deny all ftp traffic from subnet 3.4.5.0 C.) deny all telnet traffic from subnet 3.4.5.0 D.) deny all ftp traffic to subnet 3.4.5.0 E.) deny all telnet traffic
Which statement about an IP network is true? A. A broadcast source MAC address contains all zeros B. A MAC address is part of the physical layer of the OSI model C. MAC addresses are used by bridges to make forwarding decisions. IP address are used by routers. D. IP addresses allow a flat addressing scheme. MAC addresses use a hierarchical addressing scheme.
CCNA 
