Interested to Buy Any Domain ? << Click Here >> for more details...
What is the default encapsulation and frame type on an Ethernet
interface when enabling Novell?
A.) SNAP
B.) Ethernet_II
C.) 802.2
D.) 802.3
E.) SAP
F.) Token_SNAP
- 1 Answers
- 6484 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: D
By default, when an encapsulation type is not specified, the
802.3 frame
type is used.
| Is This Answer Correct ? | 1 Yes | 0 No |
Explain how many tables are in ospf protocol?
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) Show clock rate serial 0 D.) show controllers serial 0 E.) show running-config
What is a characteristic of Store and Forward switches? A.) They work at wire speed. B.) They are the same as Cut-Through switching in 'prune' mode. C.) They forward based on transport layer info. D.) They forward the frame before it is completely read. E.) They increase latency.
What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward
Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) TCP B.) Ping C.) IP D.) CDP E.) Telnet
Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S
Which statement is true regarding Administrative distance? A.) It is a metric B.) Number of hops between two routers C.) Trustworthiness of the routing information D.) RIP Administrative distance is 100
What command can be used to test IPX connectivity? A.) Ping 2e.000.0045.8923 B.) Ping 192.168.100.1 C.) Ping ipx 2e.0000.0045.8923 D.) Ipx ping 2e.0000.0045.8923
Select the physical interfaces that PPP can be configured on a Cisco router: A. Asynchronous serial B. HSSI C. ISDN D. Synchronous serial
CCNA 
