Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 2 commands that display the clock rate
configured on
the serial0 interface?
A.) show serial0
B.) show interface serial0
C.) Show clock rate serial 0
D.) show controllers serial 0
E.) show running-config
- 1 Answers
- 3773 Views
- I also Faced
- E-Mail Answers
Using the TCP/IP protocol suite a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses RARP requests D. It uses a router lookup table
Which command will copy the routers configuration from NVRAM to a Network file server? A.) copy start tftp B.) copy start tftp server C.) copy tftp startup-config D.) copy running-config tftp E.) copy startup-config tftp
mention the funtions about connection oriented and connectionless protocol and how it works ?
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
what is uplink port why are we use this port,this port having extra feature or only use to redundant link or other please explain it ,,,,,,,,,,,,,,,, bcz i am very confuse ..... Thanks
What's the default CDP holdtime in seconds for Cisco routers? A.) 30 seconds B.) 180 seconds C.) 90 seconds D.) 60 seconds
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
In port based access-list which command you give instead of ip?
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds
What is the key advantage of using a switches?
The CSMA/CD Ethernet IEEE committee is defines as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5
CCNA 
