carbon-3.23%,manganese-0.60%,silicon-2.25%,sulphur-0.086%, phosphorus-0.122%,chromium-0.04%,nickel-0.10%,molybdenum- trace.
3 5067carbon-3.23%,manganese-0.60%,silicon-2.25%,sulphur-0.086% phosphorus-0.122%,chromium-0.04%,nickel-0.10%, molybdenum-trace. WHAT IS THE GRADE OF THIS CAST IORN.
1805carbon-3.23%,manganese-0.60%,silicon-2.25%,sulphur-0.086% phosphorus-0.122%,chromium-0.04%,nickle-0.10% molybdenum-trace. what is the grade of the above composition cast iron
1684For the same part, it is possible to Specify the two different type of Hardness with same scall(EX-Quenching and tempering==>450 to 500HV30 & Hardening and Austempering 330- 380HV30)
1915what should be the exact suction capacity for 3 to 5 mt capacity lead rotary furnace and length of duct line for proper suction for same
1818sir please send me previous question papers on metallurgy at vishal.nitrr07@gmail.com .....thank you
1634
What does allotropic mean?
i want to go to US for Bachlore of computer science, I didn't appeared for SAT. my ielts scores are too low only 5.5 band and I am confused if VISA OFFICERS will ask why u hadn't given SAT. what i have to answer pl suggest?
Is it possible to determine the heat treatment condition in stainless steel (astm a 479 gr xm-19) by checking the microstructure?
What is the composition of cast grade iron 35?
What is heat treatment?
What is d2? What is it used for?
Water hammer in pipes occur due to ?
What is the chemical composition of ceramics?
What affect would increasing the charpy impact toughness on an object have on the surface of an object it strikes if all else remains the same? Would it cause moredamage to the object it strikes?
how can i prevent the backfire occurrence in copper shaft furnaces?
In grey iron sulpher was above 0.15% what react on metal?
Define grinding.
what is the strongest metal?
what is the metallurgy use?
The requirement for ASTM A217 Gr. WC9 castings for valves components like Body and Bonnet were Normalising at 920+/- 20 Deg. C and Tempring 780+/- 20 Deg. C The specification calls furnace shall be calibtated within +/-14 deg. C The Heat Chart shows minimum temperature for normalising 900 to 920 Deg. C, but maximum temperature 960-990 Deg. C Tempering 780+/-20 Deg. C is within limits and accepted. Casting having integral test bars, heat trated along with castings passed in chemical znalysis and mechanical properties. Since normalising maximum temperature is not meeting specification, where castings can be salvaged or renormalised and retempered to meet specification. Whether it will have affect on remechanical properties testing