dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
1972In Delta connected capcitor bank, One bank failed due to some problem. Can we connect Open delta capacitor bank to 3 phase motor. The motor voltage rating is 6.6KV. IF yes what changes will happen?
1 3482How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
1921I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
1 3255we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
NTPC,
1995Post New Electrical Engineering Questions
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Explain how to determine capacitor tolerance codes?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
how to test reverse power trip?
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
Iin ESP why positive is grounded ? why not negative ?
What is the difference between a verilog task and a verilog function?
Wt is the function of reactive power? How it generates & consume though resultant is zero?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
along with technical test papers
What is the lockout relay
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
send me all basic electrical question and answers
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?