Under Ground Power cable earthing is required at both end or single end? and reason for the same
3 4834sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
1775could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
1578Post New Electrical Engineering Questions
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
Yazaki india pvt ltd interview questions qurey related
how to calculate the settings for shaft ct protn in hydro generators
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
what is destructive and non-destructive testing of welding
Why AC current leads voltage in capacitor and how?
What is the disadventage of gland earthing(power cable) if any. ?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
why should the primary of transformer be connected in delta in a heat run test?
how to build a network which step down 415v to 1v rms
how you configure motorvision relay (L&T make)from DCS
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
design a LV scheme for a 15 storied building?