What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
2687A separately excited dc motor having 2 ohm armature resistsance draws a current of 10A and torque developed is 20 Nm under rated field condtion. the speed of the motor under the rated field condtion , when it is connected to a 100V DC source and delivering 10Nm torque....
DRDO,
2 5518HOW TO FIND THE PRIMARY AND SECONDARY OF TRANSFORMER(IN OFF CONDITION) USING MULTIMETER? IS IT POSSIBLE FIND BY SEEING RESISTANCE???
4 19806FOR ELECTRICAL TRANSMISSION TOWER WHAT SHOULD BE THE MINIMUM HEIGHT FROM THE GROUND? AND WHAT SHOULD BE THE DISTANCE BETWEEN THE TWO CONDUCTOR?
1 7437calculation of lad carryinc capacity of 6mm2 cross section wire in 415 voltage circuit. What will be the amps.
2055Post New Electrical Engineering Questions
Why hydropower stations are preferred solution for meeting peak loads in grids?
what is the effect of back reactive power on the generator ?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what is the difference between 2 way and 4 pole selector switch???
how to test the electrical panel.ht lt mcc pcc.
What is Antipumping Function & If we have C.T how we find the Ratio ?
WTA used cb?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
How the over load setting for HT Motors calculated-provided in Numerical Relay
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
In MEP Services what are parts of STP and what are there function?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
Hoe do calculate the Cable size for Amps rating ?