how to check the paths?

918

What is the physical representation for a many-to-many relationship?

1085

What is meany by proxy server?

1258

What is @enableautoconfiguration in spring boot? : Spring Boot

526

What remote access options does windows server 2003 support?

395

What makes a good test engineer?

1309

How does the aosp relate to the android compatibility program?

885

Compare registered vs. Bearer debentures.

988

Lowest Common ancestor in a Binary Search Tree and Binary Tree.

942

What is beanpostprocessor in spring?

406

what are the Parts of ODBC?

1858

Define Clone?

1090

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2183

In asset accounting what are the organizational assignments?

1565

What is resultset concur_updatable?

1031