What is use of LOD and LOQ in validtion and give range and in calculation why we use 3.3* LOD here why we use 3.3
- 2 Answers
- 5533 Views
- Dr Reddys, IPCA, Reddy Labs, I also Faced
- E-Mail Answers
Answer Posted / nikkosthiru@gmail.corai12
LOD is Limit of detection. We can dedect the peak but cant quantify
LOQ Limit od quaantification. We quantify also this is known as reporting thereshold.
During the RS analysis Below LOQ level we cant included in the total impurities calculation.
LOD and LOQ Determination three methods
1.S/N Ratio method
3 or 2 ratio for LOD
NLT 10 ratio for LOQ
2. Slope Method
Plot the linearity for active and impurities through serial dilution at lower level
Formula for LOD
3.3*Slope/Std.dev
Formula for LOQ
10*Slope/Std.Dev
3. Visualization method
It will be using for only identification and TLC Method
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how decide the clining method and cleaning method validation require for this perticular products?
What is delay volume?
why multimedia dissolution require to do?
Why six unit used for precision?
Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?
what is the extinction coefficient for Indomethacin or at 319nm wave length.
how to develop the icp ms method? Application of icp ms?
2. Two grams of Benzoic acid are dissolved in 200 ml of water and extracted with 200 ml of diethyl ether. The distribution coefficient of benzoic acid is 100, and its dissociation constant is 6.5 10-5. Calculate the distribution ratio (D) of benzoic acid at pH 2, 5, and 6. 3. Calculate D at pH 2 to 10 (1 unit apart) in the above problem, and plot D versus pH.
if instrument calibration fails then what require to do?
How to establish relative response factor for hplc. Why it is required?
acceptance criteria for lod & loq by standard deviation of response and slope??
i want model written test paper for the post of analyst in IOCL(indian oil corporation ltd) any one pls help me
if rsd failed then what require to do?
[3/28, 20:52] Manoj P Venkatpurwar: how many impurities require to inject in assay specificity that how we can find out? and in Rs also how?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
