Follow Our FB Page << >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

what is the difference between loss on drying in ordinary
oven technique and vacuum oven technique

Answer Posted / srikar_22

if the sample melting temperature is less than the boiling point of the solvents used in the manufacturing process then vacuum oven is preferred with out effecting the sample we get lod if not normal oven preferred

Is This Answer Correct ?    0 Yes 0 No

Post New Answer       View All Answers

Please Help Members By Posting Answers For Below Questions

how you start RS method development when for new product?


My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards


what is %labelled amount in content uniformity of dosage unit and its calculation?


mahagenco syllabus for the post of chemist


how to calculate elemental impurities?


Why do we use KMnO4 in the test of control of obsorbance ? and why do we take specific quantity i.e 57-63mg?


What is viod volume and peak purity in HPLC?


Why acetonitrile and water are used as extraction solvent when analysis melamine? I thought they are miscible and won't be able to separate...


Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?


How we performed the force degradation for drug substance, is any specific guideline is available for each parameter(Acidic, basic, oxidation,heat)? what conditions you mentained for above parameters.


What is the diference between residual solvents and organic volatile matter


what parameters we will consider while developing a HPLC method and how we confirm our HPLC method is valid?


How require to develop GC method? how to select diluent, GAS, column selection and other chromatographic conditions?


How to fix the sample conc. in Related substances test by HPLC?


While performing TOC sst analysis Zero shift disabled & sample analysis zero shift enabled why?