What is the power factor you maintain at ur organization?
Answer Posted / surya_tech4u
In cement industry maintain pf near by unity if power taken from SEB by using APFC for LT load and bus capacitor for HV system. Monthly average pf is .991 to .995.SEB generally offer insetive of 1% above .97 pf in some state.
But if CPP is there maintaining .95 to .98.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
distribution is maximum done by a)radial b)network c) parallel d)b & c
What is pi controller?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Explain how to determine capacitor tolerance codes?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
How isolater function when installed inelectrical 440V wiring
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
explain different losses in a transformer.
How to findout raw or ups power? its not indicated in socket,
What is the difference between Droop vs Isoch Control?
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
What is the vector group of a transformer,how can it be found out?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2