Interested to Buy Any Domain ? << Click Here >> for more details...
What are Line losses and how can be it minimized/controlled.?
- 2 Answers
- 3758 Views
- Omega, XYZ, I also Faced
- E-Mail Answers
Answer Posted / rk
T&D Losses= (Energy Input to feeder(Kwh)-Billed Energy to Consumer(Kwh)) / Energy Input kwh x100
Distribution Sector considered as the weakest link in the entire power sector. Transmission Losses is approximate 17% while Distribution Losses is approximate 50%.
There are two types of Transmission and Distribution Losses
Technical Losses
Non Technical Losses (Commercial Losses)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I had applied for JE in PSEB, Can you pls send me the Question bank for related to my field
by using pump duty, how we will can calculate the motor duty(KW)? is there any standard or formula.
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what is class of SPD and dittels of all class ?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
What is speed mode?
Why does amplifier gain reduce?
