What is the difference between uplc and hplc
- 4 Answers
- 24975 Views
- AAU Assam Agricultural University, Hetero, I also Faced
- E-Mail Answers
Answer Posted / khushali senghani
in UPLC productivity is increased and results are obtained mor faster with more resolution whereas in HPLC high pressure is required for solvent flow.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is the difference between spectro meter and spectro photo meter?
IS THERE ANY EQUIPMENT TO CHECK AND CALCULATE THE POLARITY OF A LIQUID?
what is mean by peak intigrity?
what is %labelled amount in content uniformity of dosage unit and its calculation?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
why glutent are detected in the rice cereal baby food product even manufacturer claimed that they are using rice and milk only?we have using ELISA to do the test,and rice supposed not containing any glutent,rite?We already repeat the test so many times and it still detected.just wondering where the glutent came from?
how to selecet an exact coloumn for an new molecule development by hplc how to select exact salt as buffer for new molecule development by hplc what is the the process to select the mode of saparation of compoundes by hplc what is the use of ph of buffer what is use of buffer,ph,organic phase,ans methods how the molecules get saparated in coloumn,
What is the diference between residual solvents and organic volatile matter
Which parameter require to do for analytical method equivalency?
[3/28, 20:52] Manoj P Venkatpurwar: how many impurities require to inject in assay specificity that how we can find out? and in Rs also how?
if you have given a blank water how you analyse by general analytical techniques?
why we should take dst factor for below 1%moisture samples
analytical method validation require to with respect to release specification or shelf life specification?
what is mean by ambient temperature?
How you develop a method in HPLC?
