Answer Posted / abhijeet

Dry Contact means contact before connecting voltage signals....while as Wet means connecting instrument in Circuit...!!!!!

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

1970

---

hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?

2098

---

Definition of reverse and acting controllers:

2312

---

Difference between ultra sonic flow meter

1993

---

all questions related to instrument technician in any offshore oil and gas company.

21671

---

I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.

2351

---

How to Calibrate Vibration Probe (Axial, Redial) in field

1140

---

For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?

5454

---

What is 1:1 redundancy ?

2381

---

What is three element in drum level?

1396

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

1658

---

Explain the working principle of lvdt?

1194

---

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

1858

---

How earthing can be checked????

2406

---

pls give me presant awerness quistion and answer in my emailid.

2862

---