Why we are use 0.005M Sulphuric acid, in control of absorbance
performance test UV Spectrophotometer calibration
Answer Posted / ramakrishna
Bcz K2Cr2O7 is easily dissolved in 0.005 M H2SO4 and stable in the solution PH below 2.0
Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
How to do regeneration of Metacarb Pb plus column?
What is the requirement for brazil in the analytical method vslidation comparr to ich?
if you get peak in blank then what require to do?
What are usp limits for theoritical plats,resoution,tailing factor,peak to valley ratio
how you start the solubility study?
Why we select scan range from higer wavelength to lower wavelength in uv visible spectroscopy and ftir spectroscopy ? .
why we should take dst factor for below 1%moisture samples
How require to develop GC method? how to select diluent, GAS, column selection and other chromatographic conditions?
how will you do the prep for unstable componds?
what is %labelled amount in content uniformity of dosage unit and its calculation?
What is the main difference between ODS1 and ODS2 Hplc column.
in dissolution why pool sample needed? in which type of drug pool sample need?
if you have given a blank water how you analyse by general analytical techniques?
For standardization of volumetric solutions, acceptance limit for concentration is considered as 10% of nominal concentration and %RSD as NMT 0.2% (for appropriate no. of replicates). But , if %RSD has not met, what should be further action?
In performance Check of GC Why Hexadecane Peak is ConsideredÂ