please send the hpcl (instrumentation) model placement
papers to my mail....
- 9 Answers
- 14145 Views
- HPCL, Invensys, IOCL, ONGC, I also Faced
- E-Mail Answers
Answer Posted / sridar
please me hpcl (instrumentation) interview questions to
sinvel2009@rediff.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are different types of valves?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Whatis the reset ofset and control system in instrumentation
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Why not come out analog output in ABB EL3020 when display show correct value
draw the block diagram of a level transmitter ?
Define cryogenic?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is instrumentation technologists and mechanics?
