Interested to Buy Any Domain ? << Click Here >> for more details...
why it is necessary to short and ground of a current
transformer secondary side?
- 6 Answers
- 9690 Views
- Ambuja, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Shorting is done ,when the ct is not in use or in case of
spare ct, to prevent development of high voltage in
secondary.Grounding is done to remove the influence of high
primary voltage due to capacitance between primary and
secondary, and insulation failure.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
what is the meaning of 0.5ohm Resistance
how to failure indution motor insulation & how to improve heat in motor insulation
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
electrical knowelge
What are hrc fuses and where it is used?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
what is upper impedance and lower impedance of a distance relay
Difference between Earthing Truck & Earthing trolly for HT panel
how to calculte capacitor range for single phase induction motors??pls tel
Explain Circuit Breaker Trip Characteristics in detail.
how point on wave controller works.
What is the magnetic field (coil DC ) of Turbo Expander?
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible
