Interested to Buy Any Domain ? << Click Here >> for more details...
Why the same type of columns showing different RT for a single
product?
- 6 Answers
- 14122 Views
- I also Faced
- E-Mail Answers
Answer Posted / reet
following factors might be the reason:
1. Column ageing
2. how the column was preserved, or what mobile phase was
used before the present experiment
3. sample preparation might be the cause. sample may be non-
homogeneous
4. Slight variation in thepH may also affect the variation
in RT.
5. Other parameters like,temperature can also be one of the
reason.
6. last but an imporatant factor might be some air bubble
trapped in the system.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
UV and PDA detector, which have less signal to noise ratio?
In the HPLC Calibration done wavelength accuracy done between 200nm-280nm .but not done remaining 300-400nm not done ?
How to set specification of assay, fisdolution and related substances?
Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?
if tech transfer fails whay require to do?
which are the diffrent batches in the pharmaceuticals?
what you do when compound having dwel wavelength?
how will you do the prep for unstable componds?
How can I develope method of dissolution by HPLC OR UV
how you fix the limits of impurities?
how require to fix the linearity and accuracy cincentration range?
Why perchloric acid used for potentiometric titration
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
how require to interprit the method precision data of hptlc?
