Why noise test is performed at 254 nm in calibration of HPLC
system?
- 4 Answers
- 16588 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhanji15
high wavelength
| Is This Answer Correct ? | 7 Yes | 17 No |
Post New Answer View All Answers
What is the diffrence in japan mkt requirement in analytical method validation over US?
AT WHAT CONDITIONS WILL YOU ANALYSE A SAMPLE,WHICH ARE PRESERVED AT OTHER THAN THE AMBIENT CONDITIONS?(ie COLD STORAGE SAMPLES BELOW 20* CENTIGRADE?
if you given one product then which tests you will perform?
Principle of single pan analytical balance
In the isomers,enantiomers give the only physical properties present such that no chemical properties present.
How will u perform degradation study in detectors other thann PDA in HPLC Methodology
can we use the same detector in HPLC as well GC and what could be the differences we can find in the final chromato graph in any aspects?
how you establish the LOQ?
1)What's the meaning of Absorption,give a example. 2)What's the meaning of Adsorption,give a example. 2)what is the difference between Absorption and Adsorption.
what is mean by peak intigrity?
if you have given one product then how you determine the impurity in that?
on the basis of bcs class how to proceed the solubility?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
How can we calculate "confidence interval" in analytical method validation? Pl. explain with example.
If vendor having more imp than monograph then how to proceed? and how to set spec?
