why synchronization done in clockwise direction?
Answer Posted / sheena mahany
i didnt get anything . be a little bit more clear....
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What does bode plots shows?
How to size fuse? How to size MCB?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Why let through energy not considered for ACB breaker while cable sizing?
what is DRP panels?
Explain the functioning of diode?
describe the Operation of induction generators from bus bars
Is any generator is developed which is operated with out diesal or other expensive source?
What does quality factor depend on in resonance?
why the neutral line is not giving shock to us if we touch it ?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
what is package substation.how many types they have
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.