What is the power factor you maintain at ur organization?
Answer Posted / rk
we are maintaing the power factor between 0.95 to 0.98.
the most economical power factor is 0.96.
if your pf is below 0.9, electrical board authorities will
impose a penalty.
Is This Answer Correct ? | 84 Yes | 10 No |
Post New Answer View All Answers
What is instrumental error?
What is the percentage loss for aluminium wire for HT line more than 11KVa
What is center gravity load in substation?
what is the difference between electrical and electronic choke?
What is Harmonics how it is produced and what is the method to control the same
what is meant by tranformer impedance?
Why front mounted CT polarities are always towards breaker?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Where burned of electricity,when,who, & why.
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
what is the purpose of silicon dropper used in battery charger?