Why the earth terminal pin is larger than phase and neutral
in three pin plug top>
- 8 Answers
- 13410 Views
- TVS, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You can insert the top in one way only ,so that the phase
and neutral wires are not interchanged and also because the
earth fault current could be higher than the load current
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how can we calculate the ratio of caustic soda and water in lrs.
What is the unit of charge and current?
What is the most important precaution in any experiment with d.c. Shunt motor?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
How Can You Relate Power Engineering With Electrical Engineering?
tell me some type of questions throught which i can prepare for exam and do my best
How 3 phase invertor works?
What Is HO factor in power selection
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
What is meant by time harmonics and space harmonics?
can the measured percentage error during calibration of single phase energy meter be negative?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
