Interested to Buy Any Domain ? << Click Here >> for more details...
Even when a particular generator in a generating station is
under maintenance we are still able to maintain the same
power output. How is this possible? Does the tie line
between 2 generating stations have a role to play in it?
- 1 Answers
- 4537 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / sudheer868
It must be noted that installed capacity of a power plant
is always designed to be greater than the load demand.Hence
if any repair or maintaince remaining all are in operation.
If no reserve capacity of plant then tie line has a role to
play.Tie line is line connecting two generating station
buses.Hence required power in one plant is obtained from
reseve capacity of other plant.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
what is droop control?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.
What is the meaning of 40X8X2 busbar dimensions for carring load of 400 Amps
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
How to select the cable and voltage drop in circuit?
if a number of plc s are there then how many modbus to be used
what are the disadvantages in GIS over AIS
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
Salient pole alternator is more stable, why?
what is the solution for meger test failed the MV cable?
How to calculate impedance volt in Transformer?
what about GD square and its important for motor design?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
