Interested to Buy Any Domain ? << Click Here >> for more details...
explain why tap changer is always connected to high voltage
winding side of the transformer.
- 10 Answers
- 43675 Views
- IOCL, UPPCL, I also Faced
- E-Mail Answers
Answer Posted / d4
The HV windings are placed on the LV windings, so it is easy
to take tappings from the HV side. Also the currrent in the
HV side is less than that on the LV side; this helps in
reducing the arcing which takes place as a result of tap
changing.
| Is This Answer Correct ? | 35 Yes | 4 No |
Post New Answer View All Answers
Explain cmrr?
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Define ohm’s law for a.c (alternating current)?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Is RTCC panel needs any control supply.
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
what is interpose? where it is used and why it is used?
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
Define rise time.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
