Interested to Buy Any Domain ? << Click Here >> for more details...
why synchronization done in clockwise direction?
- 12 Answers
- 26149 Views
- Hindalco, NTPC, I also Faced
- E-Mail Answers
Answer Posted / amit khamesra
Guys , i think , it basically depends upon the incoming
source. When u r synchronising grid with a running
generator, u need to synchronise in anti clockwise
direction, Grid being a bigger source shall supply power to
small source initially. If u r synchronising generator with
a already runing system, it shall be done in clockwise
direction as clockwise direction shows higher speed of
incoming generator, which in turn shows the load taking
capability of the incoming source.
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
if a number of plc s are there then how many modbus to be used
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
What is the difference between a 3 winding and 2 winding Potential Transformer
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
Why saturation region slowly shifted in the left side?
how to calculate current and voltage in a same circuit?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
what will happen if ac and dc supplies given
Pl. share your experience about industrial-electronics repair of machine tool.
why we can stote dc? why we cant store ac?
