Interested to Buy Any Domain ? << Click Here >> for more details...
1.what is the role of proportional comtroller in pid
controller?2.How do u calibrate the control valve?
- 3 Answers
- 11350 Views
- Bently, IOCL, I also Faced
- E-Mail Answers
Answer Posted / krishna
proportion control function is to maintain constant offset
between set point and process variable .but it cannot remove
the offset. it makes the p.v to oscillate between high and
low limits.
There are two things required for calibrating control valve
1)pneumatic tester ( signal :0.2 to 1kg /cm2
)
2) air supply source according to design of valve.
initial for 0.2 kg.cm2 valve should be (open or close )
according to ATO ATC) )
THEN CHECK POSITION AT 25 50 75 100 % OF VALVE ACCORKING TO
SIGNAL TUNE WITH POSITIONER
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Explain pH, Conductivity.
Exothermic reaction./ endothermic reaction
Please can anybody help for control valve sizing step by step procedure?
Why do we floating DC in DC system.
please tel me the calibration of pneumatic controler.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What is sensitivity in vibration probes..?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What is intrinsic safety mean.
What is Alpha & Beta fctors related to Orifice Plate & its relation with flow?
In apron feeder how TPH is calculated?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
How is PH sensor works ?
