What are all the possibilities discharge will be low in the
pumps?
- 3 Answers
- 9391 Views
- Infotech, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / karthick
i think for centrifugal pump,if the net positive suction
head is low then discharge will be affected.
and also if the pump is not able to raise pressure against
manometric head the discharge will be affected.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
Hai, i am going to appear for Section Engineer- Mechanical,RRB Chennai.Can anybody please post me the previous question papers and solutions to ajeshsudhakaran@gmail.com....
describe a type when u anticipated potential problems and development of preventive measure.
What are the 1st 2nd and 3rd laws of thermodynamics?
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
sir can u plz send me Jindal Steel's mechanical engg. paper and the aptitude paper of previous year....i wud be very thankful to u.... my email id..- suraj.candid@gmail.com
Why would you use hydraulics rather than pneumatics?
What are steam turbine parts usually come into damage?
How many 1.5 ton A/Cs can run on 7.5 kw generator (diesel)?
general diesel engine we are using 15w 40 oil unfortunatley our oiller mis used the oil hudralic oil refilled when he doing the service which kind proplem coming in future?
Hello, I am PRAVEEN, working with start-up company as design, I don have any sap experience. but I wanted to join mm course in atos. Is it good change domain?
what is the actual difference between casting and moulding? explain pressure die casting process?
Explain the rule to find specific heat of aqueous solutions.
what is the exact heat treatment cycle of IS 4522 Gr6 to get the required properties?
