Interested to Buy Any Domain ? << Click Here >> for more details...
- Civil Engineering (1773)
- Mechanical Engineering (2114)
- Electrical Engineering (5448)
- Electronics Communications (2383)
- Chemical Engineering (515)
- Aeronautical Engineering (176)
- Bio Engineering (77)
- Metallurgy (300)
- Industrial Engineering (171)
- Instrumentation (934)
- Automobile Engineering (238)
- Mechatronics Engineering (65)
- Marine Engineering (82)
- Power Plant Engineering (36)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (102)
- Engineering AllOther (932)
principle of automatic votage regulator
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
which fit is this 177-S6?
If any changes done in the process of production what that is called.
what is the use of piston rings in the engine used for a generator...........
what happen if drive input fail momentry at 48.5 HZ frequency?
Write the fetch cycle and execute cycle for following instructions:JMPNZ (jump to the given address if the accumulator not equal to zero) RET(return from a subroutine) ADB (add the contents of register B to the accumulator and save result in the accumulator).
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
plese send me the oces/dgfs sylabus and previous year question pattern of electrical engg.?
what were the challenges you faced during the project technically and how did you cope up with that?
How reactor of SBR installed , is it be over ground, fully under ground or semi sunk ?
how to calculate the settings for shaft ct protn in hydro generators
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
i am using LM7805 for my project in which 12v dc supply is given.how should i calculate the values of C0 and C1?
