Interested to Buy Any Domain ? << Click Here >> for more details...
6. Which of these statements best describes VPLS ?
- 1 Answers
- 6057 Views
- Pari Networks, I also Faced
- E-Mail Answers
Answer / moparthynani
Answer: 1. VPLS Emulates an Ethernet Switch ,With each
EMS being analogous to a VLAN
| Is This Answer Correct ? | 9 Yes | 1 No |
How can change k-value in EIGRP configuration.
Which of the following are true regarding switched virtual circuits (SVCs) and permanent virtual circuits (PVCs)? Choose two. A. SVCs and PVCs can use the same circuit. B. PVCs are permanently established virtual circuits. C. SVCs and PVCs terminate the circuit when data transmission is complete. D. SVCs are virtual circuits that are dynamically established on demand and terminated when data transmission is complete.
Which two LAN switching features apply to store-and-forward switches? A. CRC B. Frame length C. Source address D. Collision Windows
In which category should Frame Relay be placed within the following Job Aid? Name of Protocol Type of Protocol # of Users # of Hosts or Servers Comments
What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR
What are the five areas of the ISO Network Management Model? A. Performance management B. Accounting management C. Flow management D. Configuration management E. Operating management F. Fault management G. Routing management H. Security management
What type of address is analyzed by a Layer 2 switch? A. network address B. MAC and network address C. Protocol type, MAC, and network address D. MAC address
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above
Which Of the Statements best describes VPLS ?
Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes
CCNA 
