Identify 2 features of PPP PAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) More secure than CHAP D.) Remote node is control of authentication process

1 Answers  

---

Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses

2 Answers  

---

The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers  

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

1 Answers  

---

How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?

7 Answers  

---

What is the simplest way to remotely configure a router?

0 Answers  

---

What command will display all connected OSPFv2 routers?

1 Answers  

---

What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

1 Answers  

---

What is the command to start IP RIP version 1 routing on a Cisco router? A. show rip B. enable rip C. router enable D. router rip

6 Answers  

---

Which reserve port number talent use?

0 Answers  

---

how will configure Nat

6 Answers   Spanco,

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  

---