Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config

8 Answers   HCL,

---

What is the meaning of synchronization?

0 Answers  

---

Can Anybody tell me if I wanna block all MP3,video sites from cisco 2600 router,how shall i proceed with ACL's?? Please post the steps for the following alonge with detail. Thanks to you all ..appriciated

5 Answers   Cisco,

---

Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199

4 Answers  

---

What is meant arp and rarp?

0 Answers  

---

Which of the following are examples of the Session Layer? A.) IP B.) Netbios Names C.) NFS D.) Token Ring E.) SQL F.) RPC

2 Answers  

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells

3 Answers  

---

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

1 Answers  

---

You have powered on a new router and you want to create an initial configuration. Which mode should you use? A. copy mode B. user mode C. setup mode D. startup mode

4 Answers   Enrich,

---

Hi all of you, Actually this is interview qe? but i did,t do explain it completely so please give reply recently and completly Ans, what is sub-interface and inter-vlan ? And How to implement it on cisco router & switches and also which series router switches supported please write..........

2 Answers   Cisco,

---

What is the meaning of PASSIVE interface in RIP, IGRP, EIGRP & OSPF?? Can any one explain..!!!

6 Answers  

---