Answer / Dhawal Goyal

Route poisoning is a routing protocol mechanism used to rapidly spread information about a failed or unreachable network. It does this by setting the metric of the failed route to infinity, causing other routers to remove the route from their routing tables.

what is router?

9 Answers   IBM,

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

What are the 3 ways routers learn paths to destination networks? A.) Dynamic B.) Static C.) Routing tables D.) Default

1 Answers  

---

Which multicast ip eigrp protocol use?

1 Answers  

---

In how many ways you can access router?

1 Answers  

---

What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device

3 Answers  

---

1 what is private vlam 2 if there is a router which have two fast Ethernet from from fa0/0 192.168.10.0/24 network is connected from fa0/1 192.168.20.0/24 network is connected all bacsic routing is done will they communicate 3 what is difference between snmp v1 v2 and v3 what difference between name and stranded access list

2 Answers  

---

What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place

1 Answers  

---

Station A is transmitting data to station B faster that station B can handle it. When station B's buffer fills up, it send out a message to station A to stop sending data. After B empties out its buffer, station B sends a message to station A to start sending data again. This is most directly an example of (pick the best answer only): A.) Poison Reverse B.) Connectionless protocol C.) Windowing D.) Connection oriented protocol E.) Flow Control F.) Split Horizon

1 Answers  

---

What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable

2 Answers  

---

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers   Intel, Quark, Wipro,

---

Want to be a Cisco certified person through authorized training and certification center ?

0 Answers   Mercury Solutions,

---