Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces

1 Answers  

---

What is the command use to add a banner to a cisco router configuration?

0 Answers  

---

what is full form of rst,smtps & http?

2 Answers   HCL,

---

The following commands were entered at the command prompt of a Cisco router. What do they accomplish? access-list 1000 deny 9e.1234.5678.1212 4 access-list 1000 permit -1 interface ethernet 0 ipx network 9e interface ethernet 1 ipx network 4a interface serial 0 ipx network 1 ipx output-sap-filter 1000 A. File server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0. B. All other SAP services, other than file server, from any source will be forwarded on S0. C. All other SAP services, other than print server, from any source will be forwarded on S0. D. Print server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0.

1 Answers  

---

"sap" is used by the Cisco IOS for which encapsulation types? A. Ethernet_802.2 B. Token-Ring C. FDDI_SNAP D. Ethernet_802.3 E. FDDI_802.2

1 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

3 Answers  

---

What is a network subnet?

0 Answers  

---

Explain how many tables are in ospf protocol?

0 Answers  

---

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

2 Answers   Wipro,

---

What field tells the Internet layer how to handle an IP packet? A. Type of Service B. Identification C. Flags D. Frag Offset

1 Answers  

---

Which commands should you use to enable IGRP routing? A. router igrp 100 Network 192.168.1.0 Network 10.0.0.0 B. router igrp 100 Network 192.168.2.0 Network 10.0.0.0 C. router igrp 100 Network 192.168.1.0 192 168.1.1 Network 10.2.0.0 10.2.1.1 D. router igrp 100 Network 192.168.1.0 255.255.255.0 Network 10.2.0.0 255.255.255.0

3 Answers  

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

3 Answers  

---