You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

2 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers   Karrox,

---

Can you explain voluntary and compulsory tunnels?

0 Answers   CCIE,

---

Hi- Salmaan my name is Shadab Khan and nick Khangkp ok salmaam plz tell me about of NAT plz

3 Answers  

---

What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector

3 Answers   Cisco,

---

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

1 Answers  

---

what is ACLs? what is the reasons to create ACLs?

1 Answers  

---

what is different between cisco router and layer 3 switch

8 Answers   Cisco, LABA Nepal,

---

Novell NetWare has an Ethernet frame type called Ethernet_SNAP. What is the matching Cisco command line keyword for this encapsulation method? A.) arpa B.) sap C.) snap D.) gns E.) dix F.) novell-ether

1 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

2 Answers  

---

Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com

20 Answers  

---

Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config

5 Answers  

---