Interested to Buy Any Domain ? << Click Here >> for more details...
You are installing a 100BaseTX FastEthernet network in a 1-story building. The company has 100 of workstations. The rooms have 1 meter raised ceilings. What cable would you use:
a. Coax
b. Type 5 UTP
c. UTP
d. STP
- 1 Answers
- 2380 Views
- I also Faced
- E-Mail Answers
Do you know about the job of the network layer under the osi reference model?
Which protocol translates MAC addresses to IP addresses ?
Explain one basic requirement for establishing vlans?
What would you use to make a 100mb network ? budget is low.
Which option of the dhtadm command deletes the dhcptab table entirely ?
If a route to a host is fixed and does not change by the changing conditions of the network, route is called a what type of route.
Explain how to identify the ip class of a given ip address?
Which protocol is an improvement over SLIP and is supported by Solaris ?
In this subnet blocks 192.168.1.0/26 What is the range of assignable host address?
what is domain
how i can Design a client–server network with two servers operating at 100Base- T Fast Ethernet speed and the clients operating at regular 10Base-T Ethernet speed using a 10/100 Mbps NIC. The hub is located in a wiring closet, but the servers and clients are not. Assume that a satisfactory performance is achieved at 40% utilization of the LAN.
0 Answers Kent, Kent State University,
How a switch will behave for a mcast packet if Snooping is not enabled
Networking Protocols 
