Answer / indu

Bridge: Data Link

Router: Network

Repeater: Physical

Gateway: Transport, Session, presentation, application

What is the BOOT P protocol used for, where might you find it in windows network infrastructure?

4 Answers   HCL,

---

Are you familiar with automounter ?

1 Answers  

---

3 purposes of ICMP : a. router discovery b. gurantee of transport c. estimate of bandwidth d. error messaging e. diagnostics/testing f. gurantee of uniqueness of node addresses

1 Answers  

---

Explain the importance of implementing a fault tolerance system? Are there limitations?

0 Answers  

---

any one explain about frame and MAC address,packet and IP address,and segment and port address

2 Answers   IBM,

---

Port numbers for the following 2 standard services: Netstat , FTP a. 25, 81 b. 21, 15 c. 23, 80 d. 15, 21 e. 15, 22

1 Answers  

---

Which layer ensures messages reach their destination system via an optimal route (done by planning the route).

1 Answers  

---

Which command lists versions and states of the mountd service running on a host called unix1 ?

1 Answers  

---

Tell me when troubleshooting computer network problems, what common hardware-related problems can occur?

0 Answers  

---

senario: There are two switches connected via trunk port.One end station is connected to each switch via access port. All the ports are in same VLAN.All the ports have same speed 1Gbps.Start sending 1Gbps traffic from one end station to other. Determine percentage of traffic received by destination end station.

0 Answers   HCL,

---

True or False: The Transport layer deals with packets while the Data Link layer deals with frames.

1 Answers  

---

Networking?

2 Answers   CMS, XL Dynamics,

---