Which command (and options) will show the state of all sockets ?



Which command (and options) will show the state of all sockets ?..

Answer / indu

netstat -a

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Networking Administration Interview Questions

If in interview i am asked why do u want to join call center if ur computer science graduate?? what should i say??

2 Answers   Wipro,


The following are the steps toward encapsulation. Put them in order: 1. User input 2. data 3. frame 4. segment 5. datagram 6. bits a. 1-4-2-5-3-6 b. 1-5-4-2-3-6 c. 1-2-3-5-4-6 d. 1-2-4-5-3-6

1 Answers  


What is the name for the number sequence needed for handling an IP address? a. MAC b. Gateway Address c. Sock number d. Node number e. Subnet mask

1 Answers  


Which option of the dhtadm command deletes the dhcptab table entirely ?

1 Answers  


Using 10BaseT what is needed to get 300 meters :

1 Answers  


What does the ping 192.168.0.1 -l 1000 -n 100 command do?

4 Answers  


How to a software deploy in sales OU?

1 Answers  


SonicWALL keep on fail over after upgrade from 6.2.2.2 to 6.2.6.0.anyone have encounter this and what is the next step to solve the issue

1 Answers  


Three computers and a printer in the same office are all connected by a cable so that users can share the printer. Is this a LAN?

1 Answers  


Port modes [trunk and access] have any influence on VLAN tagging and un-tagging?

1 Answers   HCL,


What are the advantages of RIP ?

1 Answers  


Which protocol is an improvement over SLIP and is supported by Solaris ?

1 Answers  


Categories
  • Networking Protocols Interview Questions Networking Protocols (671)
  • Networking Administration Interview Questions Networking Administration (1008)
  • Networking Security Interview Questions Networking Security (196)
  • Networking General Interview Questions Networking General (266)
  • Networking AllOther Interview Questions Networking AllOther (430)