What is difference between tcp/ip and osi model?

0 Answers  

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

2 Answers  

---

What is the name of distance vector algorithm?

0 Answers  

---

Which three are typical operational phases in a basic connection oriented neloyord service? (Choose three) A. call setup B. data transfer C. load balancing D. call termination E. call priortization F. data segmentation G. data link identification

1 Answers  

---

What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message

1 Answers  

---

what are loops in switches excactly...and how does it gets created???

1 Answers  

---

Hello Mr.Jitendera Kuamr Sinha, how is every thing going on? Thanks for your reply. Dear Friend if you can Explain it little bit deeper i will be realy thanks full. Wish you all the Best.

1 Answers  

---

What are the generic parts of a network layer address? A. an intenetworks number and a URL B. a vendor code and a serial number C. a network number and a host number D. a broadcast number and a unicast number E. a domain identifier and a device identifier

1 Answers  

---

Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP

2 Answers  

---

IGRP uses flash updates, poison reverse updates, holddown times, and split horizon. How often does it broadcast its routing table updates? A. 90 seconds B. 10 seconds C. 30 seconds D. 45 seconds

1 Answers  

---

Which statement about the Committed Information Rate (CIP) is true? A. It is the rate in bits per second at which the Frame Relay switch agrees to transfer data B. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay cloud C. It is the maximum number of bits that switch can transferduring any Committed Rate Measurement Interval D. It is a signaling standard between the 3PE device and FP switch. It is responsible for managing the connection and maintaining status between the devices.

1 Answers  

---

What is the administrative distance for RIP? A.) 100 B.) 90 C.) 120 D.) 110

8 Answers  

---